Johnson Controls TIWM006B21S - 8.3 Contact Distributor

38
P5417053-rev.1
8.3 Contact Distributor
If problem still remains even after checking previous issues or other problems not mentioned in the previous
issues occur, stop using the product and contact your distributor or contractor.
Trouble
Action before Contacting
Contractor or Distributor
7KHSURWHFWLRQGHYLFHVIXVHEUHDNHU*)&,DQGVRIRUWK
are frequently activated or the operation switch does not
work.
7XUQ2))WKHSRZHUVRXUFH
Water Leakage from the Indoor Unit. Stop the operation.
Ɣ 7KH581LQGLFDWRUUHGLVÀDVKLQJ
Ɣ 7KHLQGRRUXQLWQXPEHUWKHDODUPFRGHWKHXQLWPRGHO
code and the number of connected indoor units are
displayed on the LCD.
Ɣ ,IPXOWLSOHLQGRRUXQLWVDUHFRQQHFWHGWRRQHFRQWUROOHU
the above abnormality informations for each indoor unit
is displayed individually.
Check the details on the LCD and contact your distributor.
Refer to Section 8.4, the alarm code table.
Contact your distributor and advise the indication
detail on the wired controller.
Provide the following information when contacting your distributor.
1) Unit Model
2) Explain the Trouble or Problem
3) Alarm Code No. on the LCD or Details of a Flashing Indicator
If an abnormality such as a burnt odor or something similar occurs, stop the operation and turn
OFF the main power source immediately. If the power source is not turned OFF, there may be
GDPDJHRIWKHSURGXFWDQHOHFWULFVKRFNRUD¿UH
Contact your distributor or contractor.
Sel. OP MODE
I.U. : RCI-3.0FSN3
MODEL : F .08
Alarm Code:
23
Indoor Unit Number
O.U. :
RAS-3HVRNM2
01-02
AlarmRST
Address
Entr
IDU :
******
ODU :
******
Chek
OK