EasyManua.ls Logo

Johnson Controls TIWM018B22S - User Manual

Johnson Controls TIWM018B22S
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P5417089
Operation
Manual
INVERTER-DRIVEN
MULTI-SPLIT SYSTEM
HEAT PUMP
AIR CONDITIONERS
IMPORTANT:
READ AND UNDERSTAND
THIS MANUAL BEFORE
USING THIS HEAT PUMP
AIR CONDITIONER.
KEEP THIS MANUAL FOR
FUTURE REFERENCE.
Type Model
Wall Mount
TIWM006B22S
TIWM008B22S
TIWM012B22S
TIWM015B22S
TIWM018B22S
TIWM024B22S
TIWM030B22S

Table of Contents

Questions and Answers

  • K
    kellyshannonAug 12, 2025
    What to do if my Johnson Controls TIWM018B22S Air Conditioner operation stopped?
    • S
      Stacey HigginsAug 12, 2025
      If your Johnson Controls Air Conditioner has stopped operating, this could be due to the micro-computer being activated to protect the device from electromagnetic waves. In this case, try restarting the operation. Also, if there was a power failure, try restarting the operation. Note that if the power failure was very brief (within two seconds), the unit should restart automatically.
  • D
    Derek SingletonAug 16, 2025
    Why does my Johnson Controls TIWM018B22S smell?
    • M
      Mary RichmondAug 16, 2025
      If you notice an odor coming from your Johnson Controls Air Conditioner indoor unit, it might be due to cigarette smoke that has infiltrated the unit. To resolve this, ventilate the unit well in fan mode and clean the air filter, the air outlet, and the air inlet grille.
  • S
    Samuel SmithAug 19, 2025
    Why is there mist coming from my Johnson Controls Air Conditioner?
    • Z
      zvaughnAug 20, 2025
      Mist coming from your Johnson Controls Air Conditioner indoor unit can occur due to several reasons. It might be caused by oil attached to the fins decreasing heat exchange efficiency, or when the air outlet temperature becomes lower. To address this, you can try changing the operation mode. You can also raise the set temperature and the air flow volume.
  • J
    Jeffrey HenryAug 23, 2025
    Why is my Johnson Controls TIWM018B22S Air Conditioner making noise?
    • P
      Phillip AguirreAug 23, 2025
      The sound from your Johnson Controls Air Conditioner indoor unit can be generated for several reasons: the components are rubbing against each other due to the extension and contraction of the resin parts caused by the temperature change; when the refrigerant flows or the drain-up mechanism drains water; or the fan motor makes temporary sound by change of fan speed.
  • D
    David GainesAug 27, 2025
    Why is there white steam from my Johnson Controls Air Conditioner?
    • S
      Sarah HuangAug 27, 2025
      White steam from your Johnson Controls Air Conditioner indoor unit may occur if dust attached to the heat exchanger has dried.
  • J
    Jordan ClarkeAug 31, 2025
    Why is there white smoke from my Johnson Controls Air Conditioner?
    • C
      Christian WeaverAug 31, 2025
      White smoke from your Johnson Controls Air Conditioner indoor unit might occur when dust attached to the heat exchanger has dried.
  • J
    Jessica SandovalSep 3, 2025
    Why is there condensation on my Johnson Controls TIWM018B22S Air Conditioner?
    • K
      Kim Barr DDSSep 3, 2025
      Condensation on the front panel of your Johnson Controls Air Conditioner might occur when the operation is performed in a humid location (relative humidity is approximately 80%) over a prolonged period of time.
  • M
    Michael BrownSep 7, 2025
    Why is there temperature irregularity in my Johnson Controls TIWM018B22S?
    • J
      Joshua PrinceSep 7, 2025
      Temperature irregularity in your Johnson Controls Air Conditioner might occur for structural reasons, such as the size of the air outlet and the location of the heat exchanger.

Summary

Introduction and Safety

Safety Instructions and General Precautions

Provides safety instructions, signal words, and general precautions for operation and maintenance.

Unit Components and Controllers

Wired Controller (CIW01) Interface

Wireless Controller (CIR01) Interface

Wired Controller Operation

Basic Operation and Mode Selection

Basic item selection, setting changes, and mode selection using the wired controller.

Temperature, Fan Speed, and Louver Settings

Wireless Controller Operation

Wireless Controller Modes

How to select operation modes (COOL, HEAT, DRY, FAN, AUTO) using the wireless controller.

Maintenance and Troubleshooting

Daily Maintenance and Filter Cleaning

Routine checks, cleaning the air filter, and resetting the filter sign.

Troubleshooting Common Issues

Identifying non-abnormal phenomena and performing pre-contact checks.

Contacting Support and Alarm Codes

Guidance on contacting distributors and a reference for alarm codes.

Johnson Controls TIWM018B22S Specifications

General IconGeneral
ModelTIWM018B22S
Voltage208-230V
Phase1
SEER22
HSPF10
RefrigerantR410A
Compressor TypeInverter
Outdoor Unit Weight88.2 lbs
TypeDuctless Mini-Split
Cooling Capacity18000 BTU/hr
Heating Capacity19000 BTU/hr
Power Supply208-230V
Outdoor Unit Noise Level54 dB
Indoor Unit Weight24 lbs

Related product manuals