P5417089
13
5.1.3 Temperature Setting
5.1.4 Fan Speed
1
Press “ ” or “ ” and select “TEMP”.
OK
Back/Hel
2
By pressing “ ”, the temperature is
increased by 1°F (0.5
o
C or 1
o
C).
(Max. 86°F (30
o
C)
By pressing “ ”, the temperature is
decreased by 1°F (0.5
o
C or 1
o
C).
COOL, FAN operation: Min. 66°F (19
o
C)
HEAT operation: Min. 62°F (17
o
C)
OK
Back/Hel
● In case the optional function “Automatic Reset of Setting Temperature” is set:
Even if changing the setting temperature on the wired controller, it automatically returns to the
temperature set by “Automatic Reset Temperature” after a set time.
● Minimum and maximum temperature setpoint limits can be congured by selecting a cooling lower limit
and heating upper limit in the “Function Selection” mode of the wired controller’s Test Run Menu.
● Contact your distributor or contractor for details on optional functions “Automatic Reset of Setting
Temperature,” “Cooling Lower Limit for Setting Temperature” and “Heating Upper Limit for Setting
Temperature.”
1
Press “ ” or “ ” and select “SPEED”.
OK
Back/Hel
2
By pressing “ ” or “ ”, the fan speed is
changed as follows.
OK
Back/Hel
● During the dry operation, the fan speed is automatically changed to “LOW” and cannot be changed to
any other fan speed. (“LOW” is NOT displayed on Liquid Crystal Display (LCD) at this time. The present
setting condition is displayed on the LCD.)
● The fan speed setting “HIGH 2” may not be available depending on the indoor unit type.
AUTO
HIGH 2
HIGH MED LOW
To Next Page
Loading...
Need help?
General
