38
P5417089
8.3 Contact Distributor
If problem still remains even after checking previous issues or other problems not mentioned in the previous
issues occur, stop using the product and contact your distributor or contractor.
Trouble
Action before Contacting
Contractor or Distributor
The protection devices (fuse, breaker, GFCI, and so forth)
are frequently activated or the operation switch does not
work.
Turn OFF the power source.
Water Leakage from the Indoor Unit. Stop the operation.
● The RUN indicator (red) is ashing.
● The indoor unit number, the alarm code, the unit model
code and the number of connected indoor units are
displayed on the LCD.
● If multiple indoor units are connected to one controller,
the above abnormality informations for each indoor unit
is displayed individually.
Check the details on the LCD and contact your distributor.
CIW01
CIR01
The type of an alarm code is determined by number of
times the indicator on the indoor unit ashes.
Refer to Section 8.4, the alarm code table.
Contact your distributor and advise the indication
detail on the wired controller.
Provide the following information when contacting your distributor.
1) Unit Model
2) Explain the Trouble or Problem
3) Alarm Code No. on the LCD or Details of a Flashing Indicator
If an abnormality such as a burnt odor or something similar occurs, stop the operation and turn
OFF the main power source immediately. If the power source is not turned OFF, there may be
damage of the product, an electric shock or a re.
Contact your distributor or contractor.
Sel. OP MODE
I.U. :
RCI-3.0FSN3
MODEL : F .08
Alarm Code:
23
O.U. :
RAS-3HVRNM2
01-02
AlarmRST
Address
Entr
IDU :
******
ODU :
******
Chek
OK
To Next Page
Loading...
Need help?
General
