14
P5417089
5.1.5 Operation
Operation
Start
Press “ ” (On/Off).
The indicator “
” is turned ON and the
operation is started.
OK
On/Off
Temperature/Air Flow Setting
● The setting is stored. Therefore, no daily setting is required. Temperature setpoint and airow settings
are retained after the indoor unit is turned OFF at the controller. In a case where the setting change is
required, refer to Sections 5.1.2 to 5.1.4.
Operation
Stop
Press “ ” (On/Off) again.
The indicator “
” is turned OFF and the
operation will stop.
OK
On/Off
● The indoor unit fan may continue to operate for up to 2 minutes following the heating cycle to dissipate
residual heat from the indoor unit.
To Next Page
Loading...
Need help?
General
