12
P5417089
5.1.2 Cooling / Heating / Fan Operation
* Cooling Operation: To decrease the room temperature.
* Heating Operation: To increase the room temperature.
* Dry Operation: To decrease the humidity in the room.
* Fan Operation: To circulate the air in the room.
Heating Operation is for VRF systems only and is not available for typical systems.
● Dry operation may not be performed properly if there are other heat sources that exceed the capacity of
the unit.
● In case where the individual setting is operating, decreasing of the humidity during dry operation might be
unavailable.
Before
Operation
Turn ON the power supply.
Turn ON the main power approximately
12 hours before operation in order to
preheat the compressor.
Do not turn OFF the main power of the
indoor unit during heating or cooling
season.
Connecting
1
Press “ ” or “ ” to select “MODE”.
OK
Back/Hel
2
By pressing “ ” or “ ”, the mode is
changed as follows.
OK
Back/Hel
● Automatic cooling/heating operation (AUTO) requires an extra setting. Contact your distributor or
contractor for details.
FAN(AUTO)DRYHEATCOOL
Function
To Next Page
Loading...
Need help?
General
