EasyManua.ls Logo

Johnson Controls VA9310 Series - User Manual

Johnson Controls VA9310 Series
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VA9310 Series Electric Non-Spring Return Valve Actuators Installation
Instructions
Refer to the QuickLIT website for the most up-to-date version of this document.
1
Applications North American Compliance
United States
Canada
IMPORTANT: Use this VA9310 Series Electric
Non-Spring Return Valve Actuator only to control
equipment under normal operating conditions.
Where failure or malfunction of the electric actuator
could lead to personal injury or property damage to
the controlled equipment or other property,
additional precautions must be designed into the
control system. Incorporate and maintain other
devices, such as supervisory or alarm systems or
safety or limit controls, intended to warn of or protect
against failure or malfunction of the electric actuator.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipmen
t
an
d receiver.
Connect the equipment into an outlet on a ci
rcuit
dif
ferent from that to which the receiver
is
conn
ected.
Consult the dealer or an experienced radio/TV
te
chnician for help.
This Class (B) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
VA9310 Series Electric Non-Spring Return Valve Actuators
Installation Instructions
VA9310-HGA-2
Part No. 34-636-2421, Rev. C
Issued March 2016
34- 636- 2421, Rev. C
Question and Answer IconNeed help?

Do you have a question about the Johnson Controls VA9310 Series and is the answer not in the manual?

Johnson Controls VA9310 Series Specifications

General IconGeneral
BrandJohnson Controls
ModelVA9310 Series
CategoryController
LanguageEnglish

Summary

Applications

North American Compliance

Special Tools Needed

Accessories

Dimensions

Mounting

Installing the Conduit Connector

Steps to install the conduit connector on the actuator.

Mounting the Actuator Inline to the Valve

Procedure for attaching the actuator inline to the valve.

Mounting the Actuator Perpendicular to the Valve

Procedure for attaching the actuator perpendicular to the valve.

Wiring

Auto Calibration Mode

Accessing the DIP Switches and LEDs

How to access the DIP switches and LEDs for calibration.

Operation

Setting the SPAN and OFFSET Proportional Command Signal to Other Values

Guide for adjusting proportional command signal offset and span.

Reading the SPAN and OFFSET Proportional Command Signal Voltage Settings

How to verify proportional command signal offset and span voltage settings.

Clearing the SPAN and OFFSET Proportional Command Signal Voltage Setting

Procedure to clear proportional command signal voltage settings.

Repositioning the Actuator Hub

Steps for manually repositioning the actuator hub.

Installing the Cover over the DIP Switches and LEDs

How to reinstall the oval cover after setup.

Removing the Conduit Connector

Steps to remove the conduit connector from the unit.

Repair Information

Technical Specifications

Related product manuals