EasyManua.ls Logo

Johnston VT651 - Sweeping Procedures

Default Icon
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter - Operation
Page Issue 01
OG
3:4
V Range 501 651 801 - Operator’s Guide
TO TERMINATE SWEEPING
1. Turn off the active switches.
2. Return the engine speed to idle,
3. Turn off ignition switch to stop engine.
Note:
To interrupt the sweeping, press the pause button. The switch will illuminate and suspend
the sweeping modes. - The engine speed will default to 1200 rev/min, deselecting the pause
button re-activates the sweeping equipment as previously selected and the engine speed
returns to the previous setting
Water Drainage
If the sweepings are waterlogged, excess water can be drained off using the drain valve
attached to the rear door.
Load De-Watering Option
Open the drain de-watering valve mounted on the rear door - See water recirculation option,
Chapter 4.
BlockedNozzleOrNozzleDuct
If it is apparent that the suction nozzle is not picking up debris it may be that it is blocked or
that the body is full.
1. With the machine stationary and the suction still operative on the nozzle, open the Maxigap/
Varagap nozzle to increase the airflow and see if the obstruction clears.
2. If not, raise and lower the nozzle and see if the blockage clears.
3. If still blocked, switch off the engine(s), open the body access door and check that the mesh
screens are clear and that the body is not full.
4. If the screens are blocked, clean them and providing the body is not full return the machine
to service and check the nozzle performance.
5. If the body is over half full the machine should be emptied at the nearest waste site.
6. If the screens are clear, the body less than half and debris is still not being picked up,it may
be that the nozzle trunking or inlet tube is blocked.
7. With the vehicle on level ground carefully raise the body and rest it on the lowest body prop
position, raising the body any higher may affect the vehicle’s stability due to the load moving
within the body. Switch off the engine(s).
8. Clear any obstruction in the nozzle or inlet duct.
All Copyright and rights are the property of Johnston Sweepers Ltd

Table of Contents

Other manuals for Johnston VT651

Related product manuals