Chapter - Routine Maintenance
Page Issue 02
OG
6:4
V Range 501 ● 651 ● 801 Operator’s Guide
Daily Maintenance - This can be carried out by a suitably trained operator.
Check the following items:
1 Oil level in hydraulic reservoir - top up if required.
2 Oil cooler radiator is not obstructed.
3 Chassis engine air cleaner - service when shown by restriction indicator.
4 Mesh screens in body are clean and fitted correctly.
5 Centre baffle is in position - duals only.
6 Mechanical damage to brush gear and report damage to supervisor.
7 Brushes for adjustment and wear - adjust or replace as required.
8 Spray jets for correct operation - clean if necessary.
9 Oil/water/leakages.
10 Chassis items as recommended in chassis manufacturer’s handbook.
WeeklyMaintenance- This can be carried out by a suitably trained operator.
Attend to/check the following:
1 Oil level in ‘HYDRODRIVE’ gearbox - top up if required.
2 Powapak bay is clean of oil etc.
3 Suction fan impeller, wear plates and intake flap for wear, renew if necessary.
4 Routing of electrics and hydraulic services for chafing.
5 Lubricate all grease points - see page OG6:18.
6 Water pump suction filters - see page 1:2.
7 Oil level and condition in Supawash pump if fitted.
50 Hour Service - To be carried out by workshop personnel.
Attend to/check the following:
1 Change hydrodrive gearbox oil.
2 Renew transmission pump filter.
3 Drain and refill Supawash pump (if fitted).
1
st
VS - Single Engine
●AttentionisdrawntotherecommendationsintheChassisEngineHandbook.
●Theseproceduresshouldbecarriedoutbyqualifiedservicepersonnel.
Safety Notice
MAINTENANCE SCHEDULE
All Copyright and rights are the property of Johnston Sweepers Ltd
To Next Page
Loading...
