JOYTECH SW300DC - 9.7.1 Base Menu

15
9.6.3 Special Remote Control Key-button
Press and hold the combination keys for 5S.
C(stop)+D(single gate) combination key -- enter into remote control learning.
9.7 Control Board Settings
9.7.1 Base Menu
Press "PROG" to enter into base menu;
Digital screen shows “NE”, select other functions of this menu by “+” and “-” buttons.
Press "SET" to confirm or to enter into sub-menu.
To exit menu, press "PROG".
If no command for one minute, the menu will automatically exit.
Base Menu
Automatic closing mode
Standard mode
Open/Close/Stop
Dual gates mode
To switch single
gate mode/dual
gates mode
Single gate mode
Community mode
Open gate
time interval
3 seconds (default)
15 seconds (default)
Automatic
closing time
To select
working mode
Initial screen