JPI JP-33 - Electric Power -Voltage Checking (for AC Line); Electrical Circuit Block-Diagram; Electrical Schematics

60 pages

Save Page as PDF

To Next Page

To Previous Page

JP-33 SERVICE MANUAL

Technical Support - Electrical Schematic

Part VI Electrical schematics

Block-Diagram of Electrical

Electrical Circuit Block-Diagram

Electric Power -Voltage Checking (for AC Line)

- -

Main Page

Maintenance Program2
Use of Maintenance Record2
Cleaning4
Daily Cleaning4
Clean the Feed Tray4
Cleaning the Film Receiver4
Weekly Cleaning5
Cleaning the DEV, FIX, WASH Rack5
Cleaning the Wash Tank5
Cleaning the Drain Filter of the DEV, FIX, WASH Tanks6
Clean the DEV, FIX, WASH Tanks and over FLOW Line7
Clean the DEV, FIX, WASH Racks7
Monthly Cleaning7
Preventative Maintenance8
Daily Inspection8
Check the Tank Levels8
Weekly Inspection8
Monthly Inspection9
Annual Inspection9
When & How to Replace Chemicals10
Procedure for Replacing the Chemistry10
Removing Old Chemistry10
Waste Disposal10
Cleaning of Rack11
Filling Processor Tanks11
Cleaning Tanks (Close Drain Valves)11
Clean Processor before Adding New Chemistry11
Install Replenishment Tanks12
Technical Support13
Table of Contents14
Trouble Shooting14
Check Film Sensor Manually.16
Cannot Insert Film, or Unit Does Not Activate When Film Is Inserted16
Check to See if Main Motor Is Operating17
Unit Continues to Operate as if Film Is Being Processed (Non-Stop)17
- Film Guide Is Dislocated or Transformed18
- Scratches or Markings on the Film that Are Perpendicular to Film Feed Direction and Are18
- Similar in Size, Distance and Location18
- Check Roller Tension Springs18
- Check if the Rack Is Dislocated18
Replenishing Rate Is too High or too Low19
- Check the Operation of the Film Detection Sensor20
- Check if the Dryer Air Is Warm or Cold20
- Check for Air Bubbles in Re-Circulation Pump or if the Pump Is Empty20
Film Is Not Dry20
During Processing You Hear Squeaking20
- Are You Receiving Electricity?21
- Circuit Breakers Continuously Trips21
- Troubleshooting for Electrical Problems21
- Unit Does Not Turn on21
- Buzzer Is Not Working22
- Display Panel Does Not Work22
- Main Motor Is Not Working22
  - Unstable Operation the Unit Turns on and off22
  - Developer Display Temperature Not the same as Actual Temperature23
- Over or under Supply of Water23
- DEV Heater Overheats24
- Dry Heater Does Not Work24
The Unit Squeaks During Operation25
Rack Jumps and Rattles25
Wrinkled Film26
- Film Is Milky27
- Film Surface Is Spotty27
- High Contrast27
- Low Contrast27
- Troubleshooting Poor Image Quality27
- Dirty Film28
- Film Emulsion Is Coming off in Developer28
- Film Is Sticking in Dryer28
- Wet Film28
- Developer Turn Dark29
- Fixer Color Is Milky29
- Increased Base Fog29
- Sandy Film29
- Scratches or Markings on Film29
- Strong Ammonia Smell from Processor29

JPI JP-33 - Electric Power -Voltage Checking (for AC Line); Electrical Circuit Block-Diagram; Electrical Schematics

Table of Contents