JR Venture CP - Engine and Clutch Assembly; Engine Mount and Cooling Fan Installation; Clutch Assembly Attachment

2-1
ENGINE MOUNT/COOLING FAN INSTALLATION
11
*It is recommended that a crankshaft locking tool be used
to properly secure the cooling fan assembly to the engine.
It is important to note the proper direction for the motor mount
installation for achieving the correct alignment of the engine.
Use Threadlock
Use Threadlock
3x30 mm Socket Head Bolt (4)
3x30 mm Socket Head Bolt (4)
3 mm Lock Nut (4)
3 mm Lock Nut (4)
3 mm Flat Washer (4)
3 mm Flat Washer (4)
3 mm Spring Washer (4)
3 mm Spring Washer (4)
Engine Nut
Engine Mount*
Cooling Fan Assembly
2x8 mm Flat Head Screw (1)
2x8 mm Flat Head Screw
3x5 mm Socket Head Bolt (2)
3x5 mm Socket Head Bolt (2)
2 mm Hex Nut (1)
2 mm Hex Nut
Steel Joint Ball (1)
Steel Joint Ball
Clutch Assembly
Longer Distance
Longer Distance
Shorter Distance
Shorter Distance
To p
Bottom
Motor Mount Direction: OS
*
To p
Bottom
Motor Mount Direction: Webra
2-2
CLUTCH ASSEMBLY ATTACHMENT
When installing the Webra .35 Heli engine, the motor mount should
be positioned in the opposite direction than what is shown for the
O.S. engine installation.
For the Webra, the longer distance of the mount should face upwards.
Please refer to the diagram above for clarification.