JR Venture CP - Tail Boom Brace Installation; Tail Fin Attachment

1-3
TAIL BOOM BRACE INSTALLATION
9
1-4
TAIL FIN ATTACHMENT
Connect the tail brace
end to the rear of the
frame as shown.
Tighten this bolt after the brace
has been connected to the rear
of the frame.
It may be neccessary to loosen these
bolts to reposition the tail brace
clamp as needed.
3x15 mm Socket Head Bolt (1)
3x15 mm Socket Head Bolt (2)
Tail Brace Clamp U/D
Preassembled
3x15 mm Socket Head Bolt
3x15 mm Socket Head Bolt
3 mm Lock Nut (1)
3 mm Lock Nut
3 mm Lock Nut
3 mm Flat Washer (2)
3 mm Lock Nut (2)
3x8 mm Socket Head Bolt (2)
3x8 mm Socket Head Bolt (2)
Vertical Fin