JR Venture CP - Washout Assembly; Swashplate Assembly

4-4
WASHOUT ASSEMBLY
4-5
SWASHPLATE ASSEMBLY
63
Swashplate Adjustment
The 120° CCPM swashplate is adjustable via the
3–4x4 mm set screws. If excessive play is found in
the test above, gently tighten each of the 3–4 mm set
screws the same amount and re-test. The swashplate
should move freely, but without notable play.
Caution: If the 3–4 mm set screws are over tightened,
damage to the swashplate bearings can occur.
While holding the inside ball race, pivot the swashplate and
check for excessive play. Adjust as necessary.
Swashplate Adjustment Test
CCPM Swashplate Assembly
Upper Swashplate Ring
Lower Swashplate Ring
4x4 mm Swashplate Adjusting Screws
(
Caution: Do not overtighten!)
4x4 mm Set Screws (3)
Ball Bearing
3x15 mm Socket Head Bolt (2)
Washout Link (2)
Washout Arm (2)
Washout Base
Steel Washer
Joint Ball (2)
2x10 mm Flat
Head Screw (2)
3x15 mm Socket Head Bolt (2)
2x10 mm Flat Head Screw (2)
3 mm Flat Washer (2)
Washout Arm Pin (2)
2 mm CA Stopper Ring (4)
Joint Ball (2)
Be careful not to over-tighten the 3x15 mm socket head bolt.
If any clearance is detected between the washout arm and the washer base, an
additional nylon washer (t0.13) can be used.
2 mm CA Stopper Ring (4)
Washout Arm Pin (2)