JR Venture CP - CCPM Servo Centering with the Sub-Trim Function

3-4
CCPM SERVO CENTERING WITH THE SUB-TRIM FUNCTION
27
JR PCM10, 10S, 10SX, 10SXII, 10X SYSTEMS
1) Enter the Sub-Trim function (Code 15).
2) Adjust the left (aileron), right (AUX 1) and front (elevator) servos as needed until the servo arm is exactly parallel to the servo as shown when
the collective stick is in the center position. It will be necessary to press the
Page button to access the right servo (AUX 1) sub-trim value.
3) Press
Enter to exit the Sub-Trim function.
XP8103, XP8103 WITH DIGTIAL TRIMS
1) With the radio power switch on, press the Up and Down keys simultaneously to enter the Function mode.
2) Press the
Up key until “Sub Trim” appears on the screen.
3) Adjust the left (aileron), right (AUX 1), and front (elevator) servos as needed until the servo arm is exactly parallel to the servo as shown when
the collective stick is in the center position. It will be necessary to press the
Sel key once to access the right servo (AUX 1) sub-trim.
4) Press the
Up and Down keys simultaneously to exit the Function mode.
[SUB TRIM]
THRO AILE ELEV RUDD GEAR
00000
ENTERPAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
+ –
CL
Press Page to access
the second screen.
Increase or decrease
value to center the
left servo.
Increase or decrease
value to center the
front servo.
[SUB TRIM]
PIT. AUX2 AUX3 AUX4 AUX5
00000
ENTERPAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
+ –
CL
Increase or decrease value
to center the right servo.
[Sub Trim]
£THRO ∞AILE
00
ELEV RUDD
00
[Sub Trim]
£GEAR ∞ PIT.
00
AUX2 AUX3
00
Increase or decrease
value to center the
front servo.
Increase or decrease
value to center the
right servo.
Increase or decrease
value to center the
left servo.
SEL
Continued