JR Venture CP - Main Drive Gear;Autorotation Assembly Installation

3-1
MAIN DRIVE GEAR/AUTOROTATION ASSEMBLY INSTALLATION
59
4x4 mm Set Screw (2)
4x4 mm Set Screw (2)
Main Shaft Collar
3x22 mm Socket Head Bolt (1)
3mm Lock Nut (1)
3 mm Lock Nut
Autorotation Assembly
3x22 mm Socket Head Bolt
Long
Short
Main Rotor Shaft
Use Blue Threadlock
Secure the autorotation hub to the main rotor shaft
using the 3x22 mm socket head bolt. Next, slide the
main shaft collar onto the main rotor shaft. While
pulling upward on the main rotor shaft, secure the
main shaft collar to the main rotor shaft using the
four 4x4 mm set screws.
(2)