4-8
ROTOR HEAD INSTALLATION
65
2.6x12 mmSocket Head Bolt (1)
3x20 mmSocket Head Bolt (1)
3 mm Flat Washer (1)
2x12 mm Flat Head Screw (2)
2x12 mm Flat Head Screw (2)
Steel Joint Ball (2)
Steel Joint Ball (2)
Rotor Head Assembly
2 mm Hex Nut (2)
2 mm Hex Nut
2.6 mm Lock Nut (1)
2.6 mm Lock Nut
3 mm Lock Nut
3 mm Lock Nut (1)
3x20 mm Socket
Head Bolt
Note: Be sure to engage the
rotor hub pin into the washout
base groove before securing
the rotor head in place.
2.6x12 mm Socket
Head Bolt
3 mm Flat Washer (2)
4x4 mm Set Screw
Flybar
Center the flybar in the seesaw shaft
before securing the flybar control arm.
4-9
FLYBAR INSTALLATION
4x4 mm Set Screw
Use Blue Threadlock
Adjust so that A and B are
exactly the same length.
A
B
(2)
(2)
To Next Page
Loading...
