JR Venture CP - Flybar Paddle Attachment; Rotor Head;Swashplate Control Rod Installation

66
4-10
FLYBAR PADDLE ATTACHMENT (TRAINER PADDLES)
4x6 mm Set Screw
4x6 mm Set Screw (2)
Insert Weight (4)
(optional)
Flybar Paddle (2)
(trainer)
3 mm Lock Nut
3 mm Lock Nut (2)
5 mm
Note proper direction of each flybar paddle
(short section forward, clockwise rotation).
Important:
Thread each flybar paddle onto the
flybar until the threaded tip of the
flybar protrudes approximately 5 mm.
Adjust each flybar paddle so they are
parallel to the flybar control arms and
to each other.
Note proper direction of each flybar
paddle (short section forward,
clockwise rotation).
Insert each weight fully to the end so
that both ends balance (optional).
4-11
ROTOR HEAD/SWASHPLATE CONTROL ROD INSTALLATION
Important:
Thread each universal link onto the
2.3 mm threaded rod to the length
shown below. Not the correct
direction of the universal link. Next,
install each rod so the JR Propo logo
faces outward.
Option: For smooth operation,
pre-size the ball links with the
JR ball link sizing tool prior to
attachment.
Seesaw Arm to Main Blade Holder (2)
(2.3x15mm threaded rod)
3 mm
Washout Arm to Flybar Control Arm (2)
(2.3x20mm threaded rod)
Swashplate to Seesaw Arm (2)
(2.3x40mm threaded rod)
JR PROPO
Universal Link
48mm
23.5mm
Trainer
19mm
3D
JR PROPO