JR Venture CP - Elevator Arm Assembly; Fuel Tank Assembly

1-3
ELEVATOR ARM ASSEMBLY
55
Elevator Arm Bushing (2)
Elevator Arm
Elevator Arm Pin (1)
Elevator Arm Pin
Swashplate A Arm
3 mm Flat Washer (1)
3 mm Flat Washer
3 mm Hex Nut (1)
3 mm Hex Nut
14.5 mm Long Ball Arm (1)
14.5 mm Long Ball Arm
1-4
FUEL TANK ASSEMBLY
45 mm
Silicone Fuel Tubing (not included)
Trim to a length of 45 mm
before installation.
Silicone Fuel Tubing (small)
Tank Grommet
Silicone Fuel Tubing (not included)
Connects to muffler pressure tap
Fuel Tank Clunk
Fuel Tank
After assembly, check to be sure the fuel
tank clunk can move from the bottom to
the top of the tank without touching the
back wall of the fuel tank.