25
XF631 MANUAL • CHAPTER 7: Functions (Function Mode)
CHAPTER 7: Functions (Function Mode) continued
Dual rate is available for the aileron and elevator
channels. The purpose of this function is to allow for
in-flight selection of two preset servo travels for each
of these channels. The amount of travel is adjustable
from 0-125%. The factory settings for both switch
positions (0 and 1) is 100%. Either position may be
selected as the low or high rate by placing the
switches in the desired position and adjusting the
value for that position. Different types of maneuvers
require varying amounts of control movements. Snap
rolls require large control movements, while smooth
maneuvers like long slow rolls are best performed
with smaller control movements. Dual rates allow
you to change the control movements in flight at the
flip of a switch. This allows you to execute maneuvers
requiring both radical control movements and small
control movements during a single flight.
DUAL RATE
•
Function Mode
7.2
1. Turn on the transmitter.
2. Press the Scroll and Increase buttons
simultaneously to enter the Function mode.
3. Press the Scroll button until “D/R” appears on
the screen.
4. Press the Channel button until the desired
channel appears on the screen. (AI = aileron or
EL = elevator).
5. The number that appears directly to the right of
the selected channel is the switch position.
There are two switch positions, 0 and 1, for each
of the channels. A “0” will appear when the
selected dual rate switch is in the uppermost
position and a “1” when the selected switch is in
the lower position.
6. The number in the center of the screen indicates
the current dual rate value for the selected switch
position and channel. Press the Increase or Decrease
button to adjust the dual rate value (0-125%).
7. After adjusting the value for the 0 switch position,
change to the 1 switch position and adjust
the rates.
8. Press the Channel button to select the other
channel and adjust the dual rate value for both
switch positions.
9. To exit, press the Scroll and Increase buttons
simultaneously.
Accessing the Servo Reversing Function