JRC JAN-9201 Instruction Manual

20-9 Section 20 Failures and After-Sale Services
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
25
26
27
Symptom Cause Action
Log is not displayed or
the values are not
displayed correctly.
The communication is not set
correctly.
Set the communication correctly.
The power supply for the log
equipment is not turned on.
Turn on the power supply for the log
equipment.
The connection with the log
equipment is abnormal.
Check the connection with the log
equipment.
When log equipment is connected to
the serial LAN interface circuit or gyro
interface circuit, check if the
corresponding LED blinks at signal
reception.
The power supply for the serial-LAN
interface circuit (CMH-2370) is not
turned on.
(Case where the log equipment is
connected to the serial-LAN interface
circuit).
Turn on the power supply for the
serial-LAN interface circuit.
The serial-LAN interface circuit
(CMH-2370) is faulty.
(Case where the log equipment is
connected to the serial-LAN interface
circuit).
Make a request to the distributor for
repair.
The Gyro interface circuit (CMJ-554)
is not set correctly.
(Case where the log equipment is
connected to the Gyro interface
circuit).
Set the Gyro interface circuit
correctly according to the log
equipment.
The Gyro interface circuit (CMJ-554)
is faulty.
(Case where the log equipment is
connected to the Gyro interface
circuit).
Make a request to the distributor for
repair.
The internal wiring is faulty.
Make a request to the distributor for
repair.
The central control unit (NDC-1590)
is faulty.
Make a request to the distributor for
repair.

JRC JAN-9201 Specifications

General

Brand	JRC
Model	JAN-9201
Category	Marine Equipment
Language	English