JRC JHS-182 - Regional Channel Setting

5-43
5.3.4.3 REGIONAL CHANNEL SETTING
When 3. REGIONAL CHANNEL SETTING is selected, Regional Channel Setting Menu appears.
A maximum eight channel management information can be inputted.
Rotate the jog dial to left/right and move the cursor for selecting the menu.
Press the Jog Dial, then the sub menu displayed
If CLR is pressed, the set up menu is displayed (5.3.4).





 Setting geographic area











The range of coordinates is set up in distance less than 200NM
[20NM or more].

[Setting Up Procedure]
1. Set up a new transmission as the picture above. Check if the settings work or not. If OK, you
can save the setting.
2. Additionally, if you want to see settings that had already been registered (maximum 9), it is
available from a list.
When this menu opens, the cursor is on 1. Press the Jog Dial then the cursor jumps to the channel
number. (e.g. In the picture above, if the Jog Dial pressed while the cursor is on 1., then it jumps to
“1222” .)
And if you rotate the Jog Dial while it is on 1., then the cursor moves 1 → 2 → 3 → 4 …
REGIONALCH.SETUTC11:44
BRG:RNG NAME/MMSI
270 ° :0.18NM
35
° :0.29NM
*22
° :0.92NM
OCEAN-LINE
QUEEN
ABCDEFG-MARU
1.CHA:1222NARROW
2.CHB:2222NARROW
3.TX/RXMODE:TX/RX,TX/RX
(CHA,CHB)
4.TXPOWER:HIGH
5.ZONESIZE:5NM
6.AREA(NE):N15 ° 22.33’
E145
° 59.99’
7.AREA(SW):N14
° 22.33’
E143
° 59.99’
8.SOURCE:BROADCASTMSG.22
MMSI:123456789
UTC:2004/07/2912:49

▼


N14°22.33’
E143°59.99’
N15°22.33’
E145°59.99’
Zone Size
CHA:1222NARROWTX/RX
CHB:2222NARROWTX/RX
TXPOWER:HIGH
Regional channel setting