JRC JHS-182 - Changing Password

5-51
5.3.4.8 CHANGING PASSWORD
Select 8. PASSWORD, then the screen for Password setting appears.
The passwords for turning off the electricity or changing channel are set up from this screen.
A person who is in charge of ship should administrate passwords.
Rotate the Jog Dial for moving the cursor.
Press the Jog Dial and submenus will be displayed.
Press CLR key for returning to SETUP MENU.


1. When the submenu is opened, the cursor is on * of the leftmost of the line of OLD. At the same
time, there is a cursor in the keyboard area of the screen.
2. Use keyboard and type in 4 digits password after “OLD:”.
3. When you type in the fourth letter and confirm by pushing the Jog Dial, then
• If the password now input matched the current password, then the cursor jumps to the
next line.
• If the password now input does not match the current password, the cursor return to 1.
4. Type in the 4 digits new password, after upper “NEW:” for creating new password.
5. When you type in the fourth letter, then the cursor jumps to the next line. Then type in new
pass word after the lower “NEW:”
・ If two passwords match, then the cursor moves to [EXIT]
・ If two new passwords don’t match, the cursor returns to 1.
6. And
・ If you select [EXIT], discard the contents and return to SETUP MENU.
・ If you select [SAVE], save the contents and return to SETUP MENU.




PASSWORDUTC11:44
BRG:RNG NAME/MMSI
270 ° :0.18NM
35
° :0.29NM
*22
° :0.92NM
OCEAN-LINE
QUEEN
ABCDEFG-MARU

1.PASSWORDSET/CHANGE
OLD:****
NEW:****
NEW:****

ABCDEFGHIJKLMNOP
QRSTUVWXYZ.0123
456789[]“#$%&’
()?@+-*/^,:;<=>!
[EXIT]
[SAVE]



Caution：
Only alphabets and numbers can be used for password.
You cannot move cursor irregularly, (such as “from 1. to keyboard area” or “Keyboard area to
[EXIT]” etc.) by rotating left the Jog Dial.
Password setting screen