6-29
5.2.7 Menu S, Settings
When pressing the MENU button in the O0 OUTPUTS menu, S0 SETTINGS is displayed.
S0 SETTINGS
WRITE ACCESS OFF
Setting concerning docking-log, NMEA syntax, NMEA delay, BT speed (SOG) input, pulse
timers, speed averaging, USB handling and network IP-address can be accessed under this
menu.
S1, System type
S1 SYSTEM TYPE
AUTO SENSE
The system can automatically detect connected speed logs and set-up the system accordingly.
When the menu is set to AUTO SENSE it will make a new scan of the inputs and choose a new
system setup. The decision is made 5 seconds after the first valid NMEA input on LOG1 Main,
LOG1 Redundancy or LOG2. The chosen system type is displayed when the menu S1 is
entered again. Alternatively, this menu can be used to manually set the type of system
according to following table.
SYSTEM TYPE Function
AUTO SENSE
T SERIES STW and SOG speed from lo
1 are supervised, In 5 and In 1
R1a STW speed from lo
1 is supervised, In 5
DUAL LOG STW and SOG speed from log 1 and 2 are supervised, In 5,
In 1 and In 2
When the setting in menu S1 is made, manually or with the AUTO SENSE function and the
systems detects incoming NMEA on these 3 inputs and this NMEA traffic does not match
current setting in menu S1, the system will set the LED code 05 on the red 2 x LED digits on
the CPU-PCB.
S2 – S5, Docking Log
S2 DL GYRO INPUT
NMEA
The rate of turn signal from the gyro can be fed to the Sig. Distributor, either via a serial
NMEA interface or an analogue DC voltage. If ANALOGUE is chosen, an additional menu
S2.2 will be used to set the scale factor of the analogue input.
S3 DL GEO BOW
0 M
Docking-log geometry, distance transducer to bow.
S4 DL GEO STERN
0 M
Docking-log geometry, distance transducer to stern.
Requirements for Docking log:
To Next Page
Loading...