6-31
S7 TX DELAY
0 MS
This menu controls the interval between serial data messages. The delay can be used to lower
data rate for slow receiver devices unable to handle messages back to back. The value is
adjustable in 10 ms steps from 0 up to 60-70 ms (default delay is 0 ms). For maximum
throughput the value shall be set as low as possible. When using the MFD5 we recommend
setting this value to 60-70ms.
S8, BT Speed Inp
S8 BT SPEED INP
LOG
Currently not implemented, but will extend the use of the Sig. Distributor to also calculate
docking-log information from other speed sources.
S9 – S14, Pulses
S9 PULSE A
WTL 200 P / NM
to
S14 PULSE F
BTR 200 P / NM
There are 6 different pulse timers (A-F) used to generate speed pulses that can be chosen for
relay and opto outputs. Following listed speeds can be set under Menu S9 – S14.
Pulse timer settin
s Function
WTL 100P Lon
itudinal STW 100 pulses / NM
WTL 200P Lon
itudinal STW 200 pulses / NM (Default for Pulse timer A)
WTL 400P Lon
itudinal STW 400 pulses / NM
WTL 500P Lon
itudinal STW 500 pulses / NM
WTT 100P Transversal STW 100 pulses / NM
WTT 200P Transversal STW 200 pulses / NM (Default for Pulse timer B)
WTT 400P Transversal STW 400 pulses / NM
WTT 500P Transversal STW 500 pulses / NM
WTR 100P Resultin
STW 100 pulses / NM
WTR 200P Resultin
STW 200 pulses / NM (Default for Pulse timer C)
WTR 400P Resultin
STW 400 pulses / NM
WTR 500P Resultin
STW 500 pulses / NM
BTL 100P Lon
itudinal SOG 100 pulses / NM
BTL 200P Lon
itudinal SOG 200 pulses / NM (Default for Pulse timer D)
BTL 400P Lon
itudinal SOG 400 pulses / NM
BTL 500P Lon
itudinal SOG 500 pulses / NM
BTT 100P Transversal SOG 100 pulses / NM
BTT 200P Transversal SOG 200 pulses / NM (Default for Pulse timer E)
BTT 400P Transversal SOG 400 pulses / NM
BTT 500P Transversal SOG 500 pulses / NM
To Next Page
Loading...