6-32
Pulse timer settin
s Function
BTR 100P Resultin
SOG 100 pulses / NM
BTR 200P Resultin
SOG 200 pulses / NM (Default for Pulse timer F)
BTR 400P Resultin
SOG 400 pulses / NM
BTR 500P Resultin
SOG 500 pulses / NM
Table 3 Pulse timer settings
S15, SPD Average
S15 SPD AVERAGE
0 SEC
This menu will affect analogue and pulse outputs as well as those NMEA outputs programmed
for NMEA listeners “SPD AVERAGE +DPT”. Rapid changes of speed will be slowed down
by the set value in this menu. If, for example, this menu is set to 5 sec, it will take 5 seconds for
a speed change to be fully indicated on the output. When choosing this setting on an NMEA
output, speed is filtered according to the time setting but transmitted DPT is unchanged
S16, USB storage
S16 USB STORAGE
FILL UP
An USB memory stick can be used to store all received and transmitted NMEA messages in the
Sig. Distributor. This menu enables activation or deactivation of the NMEA storage. Please
reboot the Sig. Distributor before inserting USB memory stick. Average storage on USB
memory stick is approx. 300 MB/24h. Menu can be set to OFF, FILL UP or NFS. Use the FILL
UP option for USB storage. Use the NFS option for NFS-disk storage on the network. The
NFS-disk network address is set in the Sig. Distributor Web interface as AUTHORISED
EXPERT.
S17, USB Erase
S17 USB ERASE
DISABLED
This menu gives the possibility to completely erase and format an USB memory. However, it
might fail depending on Sig. Distributor load and the type of USB memory.
S18 – S19, IP-Addresses
S18 LPU2 ADDRESS
IP 192.168.5.17
Specifies the IP address of the Sig. Distributor. Last digit is default set to 17 and should
normally not be changed. As “authorized” it may be set from 1 to 50. If set outside this range, it
will use 1 or 50.
S19 SERVICE PC
IP 192.168.5.56
To Next Page
Loading...