6-33
Specifies which IP address the Sig. Distributor shall connect to when accessing a service tool.
S20, BAM
S20 BAM SERIAL
DISABLED
Enables or disables serial Bridge Alert Management sentences (IEC 62923-1).
5.2.8 Menu T, Test
When pressing the MENU button in the S0 SETTINGS menu, T0 TEST is displayed.
T0 TEST
WRITE ACCESS OFF
Incoming NMEA can be simulated using the menu T1.
If the setting in menu S1 is T-SERIES, the Sig. Distributor simulates incoming NMEA as
below:
T1 TEST NMEA
T-SERIES
NMEA input signals are simulated internally by the Sig. Distributor with the following setting:
Log1Main: WTL = 20.10, BTL = 21.10, BTT = 1.10, Depth = 99.1
Log1Redundancy: WTL = 24.50, BTL = 25.50, BTT = 1.50, Depth = 99.5
GYRO_ROT: ROT = 5.30
NOTE echo sounder depth is not simulated, $SDDPT, only speed log depth $VDDPT.
If the setting in menu S1 is R1A, the Sig. Distributor simulates incoming NMEA as below:
T1 TEST NMEA
R1A
NMEA input signals are simulated internally in the Sig. Distributor with the following setting:
Log1Redundancy: WTL = 24.50
If the setting in menu S1 is DUAL_LOG, the Sig. Distributor simulates incoming NMEA as
below:
T1 TEST NMEA
DUAL LOG
NMEA input signals are simulated internally in the Sig. Distributor with the following setting:
Log1Main: WTL = 20.10, BTL = 21.10, BTT = 1.10, Depth = 99.1
Log1Redundancy: WTL = 24.50, BTL = 25.50, BTT = 1.50, Depth = 99.5
Log2Main: WTL = 22.20, BTL = 23.20, BTT = 1.20, Depth = 99.2
GYRO_ROT: ROT = 5.30
If the setting in menu S1 is AUTO SENSE this information is shown:
T1 TEST NMEA
CAN NOT SIMULATE
AUTO
Please set menu S1 before simulate NMEA.
To Next Page
Loading...