3.5.2 Save Own Ship's Track Data (Own Track Memory)
To save own ship's track data, save at a specified time interval and at a specified range
interval can be selected.
The data save interval can be selected from 10 preset time intervals and 8 preset range
intervals.
Save intervals that can be selected
Time : 3 sec, 5 sec, 10 sec, 30 sec, 1 min,
3 min, 5 min, 10 min, 30 min, and 60 min
Range : 0.1 NM, 0.2 NM, 0.3 NM, 0.5 NM,
1 NM, 3 NM, 5 NM, and 10 NM
Procedures 1 Put the cursor on own ship's track interval unit switching (lower right
of the display â‘£ on page 2-21), and press the [ENT] key.
Units of own ship's track interval are switched.
2 Put the cursor on own ship's track interval switching (lower right of
the display â‘¢ on page 2-21), and press the [ENT] key.
Own ship's track intervals are switched.
Setting the button to Off cancels the saving of data.
3.5.3 Cancel Saving of Own Ship’s Track Data (Own Track Memory)
This function cancels the saving of own ship’s track data.
Procedures 1 Put the cursor on own ship's track interval switching (lower right of
the display â‘¢ on page 2-21), and press the [ENT] key.
Own ship's track intervals are switched.
Selecting Off will cancel the saving of data.
3.5.4 Clear Own Ship’s Track Data (Clear Own Track)
This function clears own ship’s track data from memory.
Procedures 1 Open the Own Track Menu by the following menu operation.
O.TRK
2 Press the [2] key.
Clear Own Track Confirmation Window will appear.
3 Press the [1] key.
The own ship’s track data will be cleared.
3-51
To Next Page
Loading...
Need help?
General
