JRC JMA-9832-SA - Vector Constant

8 – 31
……Vector Constant (Do not change the set value carelessly) ……
1 Continue to press .
The CODE INPUT Menu will appear.
2 Press , then .
The ADJUST Menu will appear.
3 Press .
The ARPA Menu will appear.
4 Press .
will be selected.
5 To change the vector constant, enter a new value
using any of to
or and , and press to set it.
1 Press .
The ADJUST Menu will reappear.
2 Press .
The ADJUST Menu will be closed.
0
0
Exit
ENT
-
+
8
1
1.VECT CONST
1
5
ENT
0
MENU
Procedures
● The vector constant shall be set to 4 normally. If the vector constant value is higher, a target’s
vector will be better followed up when the target and own ship change their course or speed, but
the vector accuracy will be lower on the contrary.
Attention
ADJUST
ARPA
1.VECT CONST
1-8
0.
EXIT
2.
VIDEO LEVEL
4
3.LIMIT RING
OFF ON