JRC JMA-9832-SA - 3.1 FLOW OF OPERATION

3 – 1
3.1 FLOW OF OPERATION
The flow of basic operations is shown below.
Each operation will be described in detail below.
END THE OPERATION AND
STOP THE SYSTEM
ACQUIRE AND
MEASUREMENT DATA
TUNING OPERATIONS
OBSERVE AND
ADJUST VIDEO
POWER ON AND
START THE SYSTEM
● Do not put anything on the operation panel. If you put anything hot on it, it may be deformed.
● Do not give any impact on the operation panel, trackball and controls. Otherwise, any failure or
damage may result.
Attention