Section 9 Route Planning 9-36
4 Move the cursor.
5 Click the mouse button.
WPT1 is added at the cursor position.
6 Add as many WPTs as required in the same way.
7 After creating the last WPT, double-click the left button or click the right button.
The Route planning is terminated.
Note
In the case of ARCS, when a WPT is specified at a position other than the active chart and
another panel exists at the position, the panel display is switched automatically.
8 Save the route file that was created.
For the details of how to save the file, refer to "9.5 Saving a Route".
WPT1
WPT0
Rubber band
To Next Page
Loading...
