Section 6 Target Tracking and AIS 6-36
6.5.8 Operation Test for Target Tracking
Simulation is a function for determining if the target tracking function is working
correctly or not. Accordingly, this function should be used only to check for the target
tracking function operation.
In particular, if this mode is used during navigation, a pseudo target will appear on the
radar screen and cannot be easily identified from the real target. This may cause such
an accident as collision. Do not use this mode during the navigation.
The following operation test and checking are performed to check the operation of target tracking as
required. The [TT Test] dialog is used for operation.
1 Click on the [Menu] button on the left toolbar.
The menu is displayed.
2 Click on the [Settings] - [TT Test] on the menu.
The [TT Test] (Test for Target Tracking) dialog is displayed.
A pseudo-target is generated on the radar screen to check that
target tracking operates normally.
For the details, refer to "6.5.8.2 [TT Simulator] (Target tracking
simulator)".
The gate size for acquiring and tracking targets are displayed.
For the details, refer to "6.5.8.3 [Gate Display]".
The status of Target Tracking function is displayed.
For the details, refer to "6.5.8.4 [Status] display".
The operation of target detection circuit is checked.
For the details, refer to "6.5.8.1 [Test Video".
To Next Page
Loading...
