Section 5 Basic Operation of the Radar 5-32
5.4.10 Doubling the size of radar image
This function doubles the size of radar video near a specified position.
Note
If the range is 0.125 NM and the motion mode is in the TM mode, this function is not available.
1 Click on the radar signal process setting button in Radar signal information.
[RADAR Process] dialog box appears.
2 Click on the [X2(Zoom)] (double zoom) button.
Each time this button is clicked on, the double zoom function is switched On and Off.
On display:
Off display:
When double zoom is set, the cursor mode changes to the off-set cursor.
Radar signal process setting button
To Next Page
Loading...
