JRC JMR-9225-9X3 - Page 311

10-15 Section 10 Route Monitoring
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
2 Select starting point calculation method and enter a value.
Set a starting point for distance calculation by selecting [WPT] (selection of starting WPT), [Pick
on the route] (selecting any position on the starting route), or [Ship’s position] (selection of the
own ship’s position).
[WPT]: Click on a WPT used as the starting point from the combo box.
[Pick on the route]: Any position on the routes set in the starting WPT and the end WPT is
used as the starting point.
When the [Edit] (editing any position) button is clicked, the color of the
selectable route changes to green. When any position is clicked, that
position becomes the starting point.
[Ship’s position]: The own ship’s position is used as the starting point.
Click on the WPT to be passed through from the [Via WPT] combo box.
3 Select an ending point calculation method and enter a value.
Set an ending point for distance calculation by selecting [WPT] (selection of ending WPT) or
[Pick on the route] (selecting any position on the ending route).
[WPT]: Click on a WPT used as the ending point from the combo box.
[Pick on the route]: Any position on the routes set in the starting WPT and the end WPT is
used as the end point.
When the [Edit] (editing any position) button is clicked, the color of the
selectable route changes to green. When any position is clicked, that
position becomes the end point.
Memo
For schedule and distance calculation, each value is calculated using CCRP as a reference point.
Memo
When the [Edit] button is clicked on, the following message dialog box appears.
Position selection can be cancelled by clicking on the [Cancel] button.