Section 14 Creating a User Chart/ Updating a Chart Manually 14-62
Creating an object with EBL/VRM operation
1 Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Place the EBL/VRM marker on the position on which an object is to be created and
click the button.
An object is created on the position on which the button was clicked and the property
information reflected in the object property dialog box. (Refer to "14.2.8 Object property dialog
box").
4 Adjust the parameters on the object property dialog box.
5 To create an object on another position continuously, repeat Steps 2 to 4.
14.5.8.2 Clearing line
A clearing line can be created on a chart. It is possible to select an angle and either Not Less Than
(NLT) or Not More Than (NMT) for a clearing line on the object property dialog box.
1 Click on the [Type] button on the drawing toolbar.
Open the icon list and select an icon of clearing line. (Refer to "14.2.3 Selecting an object
type").
2 Click on the position of a starting point with the cursor.
A starting point is created and the property information of the clearing line is displayed on the
object property dialog box.
Starting
point
Angle of the clearing line (either NLT or NMT can be selected)
Clearing line
To Next Page
Loading...
