JRC JMR-9225-9X3 - Drawing an Object with EBL;VRM Operation

14-59 Section 14 Creating a User Chart/ Updating a Chart Manually
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
3 Enter the coordinates of the ending point and click on the [Enter] button.
An ending point of the arrow is created on the position of the specified coordinates and the
property information is reflected in the object property dialog box.
4 To create an object on another position continuously, repeat Steps 1 to 3.
14.5.7.2 Drawing an object with EBL/VRM operation
1
Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Place the EBL/VRM marker on the position of the starting point and click the button.
4 Click on the reference position of the EBL/VRM marker.
A starting point is created on the position on which the button was clicked and the property
information is displayed on the object property dialog box. (Refer to "14.2.8 Object property
dialog box").
5 Place the EBL/VRM marker on the position of the ending point and click the button.
An ending point is created on the position on which the button was clicked and the property
information is displayed on the object property dialog box. (Refer to "14.2.8 Object property
dialog box").
6 To create an object on another position continuously, repeat Steps 2 to 5.
Click
Ending point
Starting point