Section 11 Monitoring a Dragging Anchor 11-6
The preview of dragging anchor monitoring area that was set is displayed (broken line).
When the dialog is displayed, the anchor position is placed at the center of the circle.
3 Set dragging anchor monitoring to ON by clicking on the [Monitoring Anchor] button.
Dragging anchor monitoring starts based on the setting.
The dragging anchor monitoring area on the chart is changed to a solid line.
When own ship exits from the dragging anchor monitoring area, the "Outside Anchor Watch
Area" warning is displayed.
Memo
"Outside Anchor Watch Area" warning escalates to "Outside Anchor Watch Area" alarm 2 minutes
after own ship exits from the dragging anchor monitoring area.
11.2.2 Ending dragging anchor monitoring
Set the button display to [OFF] by clicking on the [Monitoring Anchor] button.
Alternatively, use the following procedure.
1 Click the dragging anchor monitoring circle.
A context menu is displayed.
2 Click [Finish Monitoring Anchor] on the context menu.
The [Monitoring Anchor] button display is changed to [OFF] and the display of the dragging
anchor monitoring area on the chart is changed to the broken line display.
To Next Page
Loading...
