JRC JUE-95SA - Page 43

3-9
3
*When E-mail or Special Access is selected to Network Type
9 Input Destination Code and Subscribers Number by alphabet (capital letter and small letter),
6 character or less.
10 Select Character Code from following choices.
・ IA5
・ DATA
11. Set Security Alart ON/OFF.
12. Input SSAS Message by one-byte character, 512 character or less.
13. Repeat the procedure from No.5 to No.12 when you edit other SSAS Scheduled data.
14. Click [SET] button to write the data into INMARSAT terminal, when setup is completed.
*When Telex is selected to Network Type
9. Input Destination Code and Subscribers Number.
Input Destination Code to first box (from left) within the range of 0 to 999.
Input Subscribers Number to second box (from left) by 11-digit figure.
10. Select Character Code from following 2 choices.
・ IA5
・ ITA2
11. Setup Security Alert ON/OFF.
12. Input SSAS Message by one-byte character, 512 character or less.
13. Repeat the procedure from No.5 to No.12 when you edit other SSAS Scheduled data.
14. Click [SET] button to write the data into INMARSAT terminal, when setup is completed.
Fig. 3.2.2d SSAS Schedule screen (Telex selected)