3-11
3
1. All data of SSAS Scheduled #1～#5 is written onto INMARSAT terminal when [SET]
button is pressed.
2. The data can not be set when winIST failed to receive the data.
3. Following pop-up message is displayed when incorrect data is input and [SET] button
is pressed.
Correct the data with reffering below mentioned Responses.
(● means number 1 to 5 of SSAS Schedule.)
・Error! Please set SSAS Schedule #● Requesting Interval data from 1 to 99!!
Response: Setup the setting value of Requesting Intertval of SSAS Schedule #●,
within the range of 1 to 99.
Fig. 3.2.2f LES1 data setup error window
・Error! Please set SSAS Schedule #● LES1 data from 000 to 063!
Response: Set the LES No. to first box (from left) of SSAS Schedule #●,
within the range of 000 to 063
NOTE
Fig. 3.2.2e Requesting Interval setting error window
To Next Page
Loading...
