ENGLISH
104
G. Zone settings
To program different zones in armed mode, follow the instructions below.
Buttons Description Note
1 (1234/4-
digit PIN
code)
+
You must be in standby
mode before you can
switch to armed mode.
* How to check you are in standby mode:
Key in the factory-set PIN code 1 2 3 4 or your new 4-digit
PIN code.
Press .
The following appears on the Smart Panel when in standby
mode.
(One beep indicates that you have entered a valid PIN code.
Three beeps indicate that you have entered an incorrect code.)
2 4-digit
PIN
code)
+
Key in the 4-digit PIN
code for setting,
followed by .
The following appears on the Smart Panel:
3
+
Press and to
switch to armed mode.
Set the zones 1, 2, 3, 4, 5, 6, 7 and 8 to ON or OFF.
If no figure is displayed, the associated zone is OFF.
The following appears on the Smart Panel:
4
Press to complete
the setting.
Confirm the setting and reset the Smart Panel to standby mode
by pressing .
To Next Page
Loading...