11
1 Introduction
1.5.1 LCD display
The following details are shown in the LCD display.
(1)
Number
While data is being recorded, or during standby for data recording, the number
of the measurement point or the user is shown here.
If stored data are displayed, the memory number for the measurement being
displayed appears in front of the “/” symbol and the total quantity of stored
data appears after the “/”.
(2)
Data logging
During manual data logging (manual recording) the REC display will only light
up when the REC key is pressed. During automatic data logging (automatic
recording) the REC display will light up continuously during recording, and will
blink during an interruption.
(3)
Input
interruption
This indicates that the input is open (probe break), short-circuited, or not
properly connected.
(4)
Battery
charge status
Indicates the charge in the battery.
(5)
Temperature
Indicates the measured temperature and the error number, if an error occurs.
(6)
°C or °F
Displays the temperature unit that is set at the moment.
r
C
Battery is full.
Battery is half full.
Battery near end of life; insert new battery.
Battery empty; insert new battery immediately.
To Next Page
Loading...
