JUMO TDA-3000 - 2.2 Setting Date, Time, and Year

2 Preparation
18
2.2 Setting the date and time
Year setup h Press the LEFT or RIGHT key to move the position where the digit is
blinking.
h Press the UP or DOWN key to set the “Year”.
h Press the SET key to save the new value.
Range of values: 0000 (only after RESET)
2003 to 9999
Setting as delivered: 0000
Month and day
setup
h Press the UP or DOWN key to set the “Day (Month)”.
h Press the LEFT key to move the blinking cursor to “Month (Day)”.
h Press the UP or DOWN key to set the “Month (Day)”.
h Press the SET key to save the new value.
Range of values: Month: 01 to 12
Day: 01 to 31
Setting as delivered: 01/01 (Day/Month format)
Time setup h Press the UP or DOWN key to set the “Minute”.
h Press the LEFT key to move the blinking cursor to “Hour”.
h Press the UP or DOWN key to set the “Hour”.
h Press the SET key to save the new value.
Range of values: Hour: 00 to 23
Minute: 00 to 59
Setting as delivered: 00:00
Version number The version number of the device software is shown in the LCD display.
Setting
end
h Press the ESC key twice: this brings you back to the normal display. Or
press the MENU/POWER key for longer than two seconds: this will switch
off the instrument.
Month/Day format Day/Month format
Month Day (cursor blinks) Day Month (cursor blinks)