Procedure
• Press the ENTER key (36).
• Press the Increase value key (37) or Decrease value key (36) to change the tare
weight. Press the Skip (35) to skip to the next field. Repeat this operation until the
desired value is displayed.
Activate or save the tare weight:
Procedure
• To confirm the value, keep the Confirm key (35) pressed for three seconds.
The tare weight is now activated (NET segment (31) active). If at this time the
system is laden, the net value for the weighed weight will appear in the display. If
at this time the system is unloaded, the display will show the entered tare weight
as a negative value.
Z
The entered value will remain active until the weighing system is switched off, a new
tare weight is entered, a new load is tared or a new zero setting is performed.
Activate and save the tare weight:
Procedure
• Confirm all segments by pressing the Confirm key (35). The tare weight is now
activated (NET segment (34) active) and is saved. If at this time the system is
laden, the net value for the weighed weight will appear in the display. If at this time
the system is unloaded, the display will show the entered tare weight as a
negative value.
Z
The entered value will remain active even after the system is switched off, until a
new tare weight is entered, a new load is tared or a new zero setting is performed.
Deactivating the tare weight by performing a Zeroing:
Procedure
• If the weighing system is loaded: Keep the PT key (36) pressed for two seconds.
The tare weight is reset. The system reverts to standard weighing mode.
• If the weighing system is unladen: Press the 0/T key (35).
A zero correction will be performed. The system reverts to standard weighing
mode.
63
11.19 en-GB
To Next Page
Loading...
Need help?
General
