Inputting a new identity code number:
Procedure
• Keep the No key (49) pressed for three seconds. The identity code number most
recently input will be displayed. The last position on the right of the display will
flash.
• Press the Increase value key (51) or Decrease value key (50) to change the
identity code number . Press the Skip (52) to skip to the next field.
Repeat this operation until the desired value is displayed.
• Press Confirm (49) to load the displayed value.
The identity code number will be accepted. The weighing system reverts to
weighing mode.
Z
The identity code number "00000" is not reported separately on the print-out.
Piece Counting by Calculating the Piece Weights
Pieces can be counted using a known or weighed piece weight. Larger differences in
weight and larger quantities for determining the piece weight result in more accurate
piece weights. The piece weight and the calculated quantity of pieces can be printed
out.
Z
The difference in weight for calculating the piece weight should not be less than 4 to
5 kg.
Piece counting over a piece weight to be weighed, preset to 10 pieces:
Procedure
• Press the piece weight key (52).
The message “Add10“ is displayed. The unit displayed changes from "kg" to
"pcs".
• Increasing or reducing the number of goods placed on the load handler by 10
pieces.
• Press the Confirm key (49).
The calculation of the piece weight will be performed. The quantity of pieces
determined by the weighing will be displayed.
70
11.19 en-GB
To Next Page
Loading...
Need help?
General
