Piece counting over a piece weight to be weighed, with a different quantity of
pieces:
Procedure
• Press the piece weight key (52).
The message “Add10“ is displayed. The unit displayed changes from "kg" to
"pcs".
• Press the Increase value key (51) or Decrease value key (50) to change the
quantity of pieces to a maximum of 95 pieces.
Z
If the accuracy of the piece weight that was determined is too low, the display
message "Err05" appears. Press any key to acknowledge and to increase the
quantity of pieces.
• Increasing or reducing the number of goods placed on the load handler by the
number of pieces entered.
• Press the Confirm key (49).
The calculation of the piece weight will be performed. The quantity of pieces
determined by the weighing will be displayed.
Counting the pieces over the piece weight that was entered:
Procedure
• Keep the Input Piece Weight key (52) pressed for three seconds.
The most recently input piece weight will be displayed. The last position on the
right of the display will flash.
• Press Confirm (49) to load the displayed value.
The quantity of pieces determined by the weighing will be displayed.
To input a new tare piece weight:
71
11.19 en-GB
To Next Page
Loading...
Need help?
General
