Procedure
• Keep the Input Piece Weight key (52) pressed for three seconds.
The most recently input piece weight will be displayed. The last position on the
right of the display will flash.
• Press the Increase value key (51) or Decrease value key (50) to change the piece
weight. Press the Skip (52) to skip to the next field.
Repeat this operation until the desired value is displayed.
• Press Confirm (49) to load the displayed value.
The quantity of pieces determined by the weighing will be displayed.
End the piece counting to revert to standard weighing mode:
Procedure
• Keep the Change Over key (53) pressed for three seconds.
The system reverts to standard weighing mode. The quantity of pieces that was
determined is cleared down.
Addition of individual weighings:
Procedure
• Load the system with the load to be added.
• Press the ± key (51) to add the weighed weight to the saved total weight.
The gross, net and tare weights will be added. The weight summation is
confirmed with the display message "Added". The system reverts to standard
weighing mode. If the system is fitted with a built-in printer (o), the displayed value
will be printed out.
Z
No weight can be added twice. The system must be brought into the zero range
before a second weight can be added.
To display the total weight:
72
11.19 en-GB
To Next Page
Loading...
Need help?
General
