Procedure
• Keep key (51) pressed for three seconds; the total weight calculated thus far will
be displayed.
Z
The display shows the current number of weighings alternating with the total weight
on a three second cycle. If no key is pressed whilst this display is being shown, the
system reverts to standard weighing mode after 60 seconds. The current total weight
is retained in the memory.
Resetting the total of individual weighings, with print-out:
Procedure
• Press key (51) for three seconds whilst the total weight is being displayed.
The total weight will be reset. A cumulative printout is performed before the total is
reset.
Resetting the total of individual weighings, without print-out:
Procedure
• Press the On/Off key (53) whilst the total weight is being displayed.
The total weight will be reset.
Switching the unit of weight display between "kg" and "lb":
Procedure
• Keep the Change Over key (53) pressed for three seconds.
The current weight will be displayed for 5 seconds in the second unit of weight.
The display switches automatically back into the preset start unit of weight.
Z
Whilst the display is showing weights in the change-over unit of weight, the weighing
functions cannot be performed: If any key is pressed, the display message "Err99"
appears. The system reverts to standard weighing mode.
73
11.19 en-GB
To Next Page
Loading...
Need help?
General
