To Next Page

To Previous Page

03.11 EN

7 Load handler emergency lowering

WARNING!

Lowering the mast can result in injuries

XInstruct other people to move out of the hazardous area of the truck during

emergency lowering.

XNever stand underneath a raised load handler / driver's cab.

XIf a second person is used to lower the load handler via the emergency lowering

device, this person must consult with the driver. Both people must be in a safe area

to avoid danger.

XReport any defects immediately to your supervisor.

XTag out and decommission a faulty lift truck.

XOnly return the truck to service when you have identified and rectified the fault.

Load handler emergency lowering

Requirements

– Load handler is not in the rack.

Tools and Material Required

– Allen key (2.5 mm)

Procedure

• Set key switch (12) to "0".

• Pull the Emergency Disconnect (battery connector) switch (8). (see "Emergency

Disconnect" on page 47).

• Open the front cover (17). (see "Removing the front panel" on page 79).

• Undo the screw on the valve manifold (53) with an Allen key.

The load handler is lowered.

Z After carrying out the emergency lowering, turn in the screw on the valve manifold

(53) again as far as the stop.