To Next Page

To Previous Page

A 1

0504.GB

A Correct use and application of the truck

The “Guidelines for the Correct Use and Application of Industrial Trucks“ (VDMA) are

supplied with the truck. The guidelines form part of these operating instructions and

must be observed. National regulations apply in full.

The truck described in the present operator manual is an industrial truck designed for

lifting and transporting load units.

It must be used, operated and serviced in accordance with the present instructions.

Any other type of use is beyond the scope of application and can result in damage to

personnel, the truck or property. In particular, avoid overloading the truck with loads

which are too heavy or placed on one side. The data plate attached to the truck or the

load diagram are binding for the maximum load capacity. The industrial truck must

not be used in fire or explosion endangered areas or in places which can result in

corrosion or produce dust.

Proprietor responsibilities: The “proprietor” within the meaning of this operator

manual is defined as any natural or legal person who either uses the industrial truck

himself, or on whose behalf it is used. In special cases (e.g. leasing or renting) the

proprietor is considered the person who, in accordance with existing contractual

agreements between the owner and user of the industrial truck, is charged with

operational duties.

The proprietor must ensure that the truck is only used for the purpose it is designed

for and that all dangers to life and limb of the user and third parties are avoided.

Furthermore, accident prevention regulations, safety regulations and operating,

servicing and repair guidelines must be followed. The proprietor must ensure that all

truck users have read and understood this operator manual.

Failure to comply with the operator manual shall invalidate the warranty. The same

applies if improper work is carried out on the truck by the customer or third parties

without the permission of the manufacturer’s customer service department.

Mounting attachments: The mounting or installation of additional equipment which

affects or supplements the performance of the industrial truck requires the written

permission of the manufacturer. In some cases, local authority approval shall be

required.

Approval of the local authorities however does not constitute the manufacturer’s

approval.

A 1