EasyManuals Logo

Jungheinrich EKS 310k User Manual

Jungheinrich EKS 310k
97 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
0708.GB
F 16
6.2 During decommissioning:
Every 2 months:
Charge the battery (see Chapter D).
M
Battery powered trucks:
The battery must be charged at regular intervals to avoid depletion of the battery
through self-discharge. The sulfatisation would destroy the battery.
6.3 Recommissioning
Thoroughly clean the truck.
Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
Clean the battery, grease the terminals and connect the battery.
Charge the battery (see Chapter D).
Check transmission oil for condensed water and replace if necessary.
Check hydraulic oil for condensed water and replace if necessary.
Start up the truck (see Chapter E).
Z
Battery powered trucks:
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the operating
controls by applying them repeatedly.
F
Perform several brake tests immediately after starting the truck again.
0708.GB
F 16
6.2 During decommissioning:
Every 2 months:
Charge the battery (see Chapter D).
M
Battery powered trucks:
The battery must be charged at regular intervals to avoid depletion of the battery
through self-discharge. The sulfatisation would destroy the battery.
6.3 Recommissioning
Thoroughly clean the truck.
Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
Clean the battery, grease the terminals and connect the battery.
Charge the battery (see Chapter D).
Check transmission oil for condensed water and replace if necessary.
Check hydraulic oil for condensed water and replace if necessary.
Start up the truck (see Chapter E).
Z
Battery powered trucks:
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the operating
controls by applying them repeatedly.
F
Perform several brake tests immediately after starting the truck again.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jungheinrich EKS 310k and is the answer not in the manual?

Jungheinrich EKS 310k Specifications

General IconGeneral
BrandJungheinrich
ModelEKS 310k
CategoryForklifts
LanguageEnglish

Related product manuals